Tuesday, 20 March 2012
Spinning with BRADA
Materials: BRADA laptop support, PVC pipe/tee, nuts/bolts, hacksaw, sand paper, drill
Description: Recently purchased a indoor bike and wanted the ability to read at decent angle or use a tablet (really helps the time fly!). Had the BRADA laptop support lying around, but it didn't quite fit the bill (too low of an angle angle unstable).
All I did was cut a small segment of 1 1/2" PVC in half for the front 'feet' supports to prevent the BRADA from slipping down and 2 PVC Ts connect to each other with 1" PVC to make the back support to give it just the right angle.
All pieces are secured to the BRADA using short/small nuts and bolts.
The grips on the bike handles make this apparatus surprisingly stable.